EasyTechnology - Προϊόντα τεχνολογίας και επισκευές, Η τεχνολογία γίνεται εύκολη με εμάς!

Το ArctiClean είναι ένα σύστημα καθαρισμού, δύο σταδίων, για θερμοαγώγιμες πάστες ή Pad και προετοιμάζει τη θερμική επιφάνεια για μια νέα εφαρμογή. 2-Step Process: Το ArctiClean 1 Thermal Material Remover διαλύει το υπάρχον ΤΙΜ ή pad από επεξεργαστές και ψύκτρες, ώστε να μπορεί εύκολα να αφαιρεθεί με ένα καθαρό ύφασμα ή απορροφητικό χαρτί. Ενώ το ArctiClean 2 Thermal Surface Purifier αφαιρεί τα κατάλοιπα και αναστέλλει τη διάβρωση σε χαλκό ή αλουμίνιο. ArctiClean 1 Thermal Material Remover quickly emulsifies and dissolves the existing thermal grease or pad from the CPU and/or heatsink so that it can easily be removed with a clean cloth or paper towel. A few drops of ArctiClean 2 Thermal Surface Purifier and some gentle wiping then removes the remaining residue and inhibits flash corrosion on copper or aluminum. ArctiClean 1 Thermal Material Remover: ArctiClean 1 uses a proprietary combination of non-toxic biodegradable solvents to emulsify thermal greases or thermal pads. The citrus and soy based solvents in ArctiClean 1 match or exceed many hazardsous and volatile solvents such as fluorinated and chlorinated organic solvents, acetone, MEK (methyl ethyl ketone), mineral spirits, isopropyl alcohol, and toluene. ArctiClean 2 Thermal Surface Purifier: The cationic surfactants in ArctiClean 2 remove any residue left by the ArctiClean 1 leaving a pristine surface for the application of a new thermal interface material. It also incorporates advanced flash corrosion inhibitors that minimize the corrosion layer on copper and aluminum allowing for more intimate contact between the thermal interface material and the heatsink. Using ArctiClean 2 With Other Solvents: Most solvents and cleaning products leave residue on the CPU and heatsink that negatively affects the performance of any subsequently applied thermal interface material. ArctiClean 2 Thermal Surface Purifier removes the residue of citrus or petroleum based cleaners and inhibits flash corrosion on a copper or aluminum heatsink. Why Not Just Use Isopropyl Alcohol or Acetone? Put isopropyl alcohol or acetone on a thermal pad and 10 minutes later you will have a thermal pad. Only with a lot of rubbing and scrubbing will you be able to remove the pad. While the alcohol or acetone may soften the pad, neither actually dissolves the pad. Although less visible, it is the same cleaning thermal greases with alcohol or acetone.