EasyTechnology - Προϊόντα τεχνολογίας και επισκευές, Η τεχνολογία γίνεται εύκολη με εμάς!

Instructions (with soldering iron or heat gun) Apply flux to all leads. Melt QuickAlloy SMT1-L uniformly on all pins (you need the temperature to be high enough to actually melt the original leads at least once in order to get the desired result as described). Maintain alloy in molten state long enough to release chip (or FPC connector). Lift chip from board with a pick or tweezers. You can use this to change iPod, iPhone, iPad, dock connector, FPC connector, coil, resistor, wifi holder, battery connector (this is what we use in our repairs) CLEAN UP While molten, use cotton swab and flux to move excess to an unused section of board (Usually the middle of where the component was). While applying heat, polish each pad with a swab and flux until thoroughly clean. At room temperature clean residue with alcohol. You are now ready to install the new chip. This alloy is recyclable and reusable for many repairs, simply heat it up with the soldering iron and you can reuse the alloy lump in your next repair job.