EasyTechnology - Προϊόντα τεχνολογίας και επισκευές, Η τεχνολογία γίνεται εύκολη με εμάς!

•Works on iOS 4.1, 4.2, 4.2.1, 4.3, 4.3.1, 4.3.2, 4.3.3 and (5, 5.1 with PRESERVE BaseBand 4.10) Compatible with Firmware Versions 4.1 / 4.2.1 Description: This is the latest untethered and most stable version from Gevey. Notes: When connecting the phone to the computer, please do not upgrade to iOS5 and above software version, otherwise the phone cannot be unlocked. How to use the Gevey Ultra? 1. Jailbreak your iPhone 4, (need to do manually; if you do not have Cydia, visit iclarified.com then go to their tutorials section) 2. Open Cydia and add http://www.x3groove.com to cydia source. 3. Install FusiousMod.com. Click FusiousMod.com>FuriousMod>Install>Confirm, start installation, Click restart Spring Board. If the installation is success, a red FuriousMod icon will be appeared. 4. With the use of the transparent sticker from the package, cut the SIM card in the exact same size. Make sure the edge of the SIM card has 1mm gap apart from the black square chip. (Important Note: If the chip on the SIM Card contact with the chips bottom, it will cause the chip short circuit, and it will show NO SIM on the iPhone.). After cutting the sim, put your sim card on the gevey ultra sim tray and insert into the iPhone. 5. Turn on your iPhone 4. Welcome Message screen will appear. Turn on the phone, if a dialog pops up, click Cancel, no other operation is needed, wait 1-2 minutes for the phone signal to be appeared. If after 5 minutes, there is no signal appearing, please restart the phone without reinsert the card holder, and wait for the phone signal to be appeared. 6. NOTE: Gevey Welcome Message will show up, then followed by the "No Sim" message. Do not worry. Nothing you need to do, just patiently wait for 1-2 min. 7. Note: This item can be used if the phone has not been jail break. Click Setting>Phone>Sim application>Turn on Language. After that follow the steps that same as Gevey Pro and dail 112, and wait until the signal to be appeared. When restarting the iPhone, you need to redo the whole process